Documentation for ACFA PSIM 1.3.

Previous page Configuring the V2000 Controller Keypad Types  Configuring V1000 Controller Devices Next page

To configure V2000 controller's readers, use the setup panel of the relevant Reader (V2000) object. To find this object, go to the Settings dialog box, click the Hardware tab, select the relevant VertX V2000 NC/RI object, and browse its object subtree.

To configure the readers:

  1. Go to the Reader (V2000) object's setup panel.
  2. Select the position of the reader in the Position field (1).
  3. Select the type of reader used in the Reader type field (2).
  4. Set the access mode by selecting it from the corresponding drop-down list (3).
  5. Check the Reader I'm alive enabled box to enable the reader (4).
  6. Select the Report I'm alive message to the controller to send a notification to the controller about the connected reader (5).
  7. Select the time to send the message after connecting the reader in the Message time field (6).
  8. Select the message code in the I'm alive message field (7).
  9. Check the Reader accepts PIN commands box to enable the use of PIN-codes on the reader (8).
  10. Select the length of the PIN in the PIN length field (9).
  11. Select the number of attempts to enter the PIN in the Attempts field (10).
  12. Specify the digital code associated with the end of the PIN entry in the End of PIN code field (11).
  13. Specify the digital code associated with the clearing command of the entered PIN in the Clear code field (12).
  14. Select the keypad type from the drop-down list (13).
  15. Set the maximum time for entering the PIN in seconds in the Maximum time for entering PIN, sec field (14).
  16. Set the pause in seconds, during which the reader will not accept attempts to enter the code, if the limit of dialing attempts is exceeded (15).
  17. Select the mode for suppressing the PIN-schedule in the Card and PIN access mode in the Suppress PIN (Card and PIN) field (16).
  18. Select the type of antipassback control in the APB type field (17).
  19. Set the time period for timed antipassback control in seconds (18).
  20. Select the action to take when the antipassback is registered by setting the corresponding switch (19).
  21. Select the region which the user enters in the Enter field (20).
  22. Select the region from which the user enters in the Exit field (21).
  23. Click the Apply button to save the changes (22).

Configuring the V2000 controller reader is completed. 

  • No labels