Documentation for ACFA PSIM 1.3.

Previous page Capturing fingerprints of Access Manager users with Suprema RealScan  Working with FOH02 control reader Next page

Verification of user authentication using the Suprema RealScan control reader is performed as follows:

  1. Go to adding biometric data in the Access Manager window (see Adding biometric parameters).
  2. Select the (Fingerprint Authentication) Suprema RealScan extension that corresponds to the Suprema RealScan control reader.
  3. The Suprema. Autentification window will open.
  4. From the Quality drop-down list (1) select the fingerprint capture quality:
    • 20 (Weak) - low quality.
    • 40 (Moderate) - average quality (default).
    • 60 (Strong) - high quality.
    • 80 (Strongest) - the highest quality.

  5. To start capturing fingerprints, click the Start capturing button (2) and follow the instructions displayed at the top of the Suprema. Autentification window.

    Note

    The finger should be attached with 5 seconds delay after clicking the Start capturing button.

  6. As a result, if there are no fingerprint matches, the Matches not found message will be displayed at the top of the Suprema. Autentification window.
     

    If fingerprint matches are found, then the Matches found message will be displayed at the top of the Suprema. Autentification window.

  7. To open the door for entrance, click the Access in button (1).

  8. To open the door for exit, click the Access out button (2).

  9. To close the Suprema. Autentification window, click Cancel (3).

Verification of user authentication using the Suprema RealScan control reader is completed.

  • No labels