Previous page Next page


Configuring the BioSmart UniPass controller and the Biosmart PV-WTC terminal can be performed both automatic and manual creation.

For this do the following:

  1. Go to the settings panel of the Biosmart Unipass or Biosmart WTC object, which is created on the basis of the Biosmart Palm Vein.

  2. From the Working Mode drop-down list (1) select the controller / terminal operation mode, which corresponds to the serial number of the operation model in the web interface.
  3. From the Number of templates per user drop-down list (2) select the number of possible patterns of the user's palm vein pattern. Up to 10 templates are available for each user.
  4. From the Time without getting queries drop-down list (3) select the time period in seconds and if there are no requests from the server for this period, the connection with the server will be forcibly disconnected.
  5. From the System mode drop-down list (4) select the system operation mode:
    1. Network - an operation mode in which access to the controller / terminal is assigned from the manufacturer's utility BioSmart Studio v5. Hand patterns are stored in the controller / terminal memory.
    2. Local - operating mode of BioSmart-WTC2 terminal which is not supported in the current version of integration. Differs from the Network operation mode by the database storage logic.
    3. Server identification - a mode of operation in which palm images are stored on an external biometric identification server instead of the controller or terminal local memory. In this mode, comparison of biometric data is performed on an external server, which allows you to expand the number of images and increase the speed of identification. The following parameters of the external Biometric Identification Server must be specified:
      1. In the Host IP field (1), enter the IP-address of the Biometric Identification Server.

      2. In the Host port field (2), enter the port of the Biometric identification Server.

        Important!

        If the Server identification mode is used, then the Identification Server must be configured (see Configuring the Biometric Identification Server).
  6. Click the Save configuration button to write the settings to the controller / terminal (see Biosmart Unipass and Biosmart PV-WTC configuration management).
  7. Click Apply (5).

Configuring BioSmart UniPass and Biosmart PV-WTC is now complete.

  • No labels