Previous page Next page


To configure AAN controller ports used to connect minor controllers (AIM) proceed as follows:

  1. Go to the AAN Controller object settings panel.
  2. Click Configuration of controller ports(1). The AAN ports configuration dialog box opens. One can configure ports 3 to 6 using  this dialog box. Settings are similar for all ports.
  3. In the Mode drop-down list select the mode of data transmission through port: full-duplex or half-duplex (1)
  4. Specify the transfer delay in milliseconds (2).
  5. Specify the delay before receiving data in milliseconds ( 3).

  6. Specify the maximum time for waiting  the next byte in milliseconds (4).

    Note.

    In the name of this and subsequent settings the multiplicity of the specified value is indicated after comma. Thus, if you set the  Maximum time between bytes, 10 ms value equal to 4, the maximum time for waiting  the next byte will be equal to 40 ms.
  7. Specify the reply time (5) taking into account given multiplicity.
  8. Specify the poll period when the link is present in milliseconds (6) taking into account given multiplicity.
  9. Specify the poll period when the link is lost in milliseconds (7) taking into account given multiplicity.
  10. Click Apply (8).
  11. Click Apply  on the settings panel of the AAN Controller object (2).

Ports of the AAN controller are now configured.