Previous page Next page


Synchronization of the ADPRO integration module hardware tree allows automatically creating required Detector objects in the ACFA Intellect hardware tree.

In order to synchronize the ADPRO integration module hardware tree proceed as follows:

  1. Go to the ADPRO object settings panel.
  2. Click Sync.
  3. The synchronization start is followed by the Command start event displayed in the Event viewer window. When synchronization finishes, the Command done event is shown. For both events the "SYNC" text is displayed in the Add. info column.

The objects corresponding to the connected detectors are created in the objects tree on the basis of the ADPRO object.

 

The detector type and its number on the line are displayed on the Detector object settings panel.

 

Note.

When the Disable checkbox is set on the settings panel of the XTRALIS_DETECTOR object, the detector goes into the DISABLED state and is no longer scanned.

When the Disable checkbox is unset again, the detector scan restarts and the object's state on the Map is updated.

There are four types of Detector objects as described below:

Detector type in ACFA-IntellectCorresponding ADPRO detectors
ADPRO detector 1PRO E-45 / PRO E-45H / PRO E-18 / PRO E-18H / PRO E-18W / PRO E-18WH / PRO E-30 / PRO E-40
ADPRO detector 2PRO E-45D / PRO E-45DH
ADPRO detector 3PRO E-100 / PRO E-100H / PRO E-400H
ADPRO detector 4PRO E-51 / PRO E-85 / PRO E-85H

Synchronization of the ADPRO integration module hardware tree is now completed.

  • No labels