Documentation for Auto Intellect 5.4. Documentation for other versions of Intellect is available too.

Previous page Next page

The Uragan module can operate together with the LPR channel.

When LPR channel and Radar modules operate together, Radar determines the speed of the vehicle whose LP number is recognized by the LPR channel.

Note.

This settings is specified only when the Auto-Uragan, CARMEN-parking, CARMEN-auto or VIT program modules are in use.

To set up the joint operation of the LPR channel and Radar, do the following:

  1. In the System Settings dialog window, open the Hardware tab.
  2. In the object tree on the left side of the Hardware tab, select the LPR channel, corresponding to the activated Auto-Uragan, CARMEN-parking or CARMEN-Auto program module in the objects tree on the Hardware tab (see Activating the program module, used for identifying the plates section). The settings panel of the selected object will open on the right side of the window.
  3. Go to the Speed camera settings tab (3).
  4. In the Speed camera settings drop-down list, select the Speed-trap object representing the speed-trap device directed at the same lane as the LPR channel camera (4).

  5. In the Synchronization time field, enter the time period in milliseconds that it takes the vehicle to drive from the spot of speed detection by the Radar speed-trap to the viewing zone of the LPR channel recognition video camera (5).

    Note.

    Synchronization time is needed to synchronize the operation of the Radar and the LPR channel modules.

  6. Check the Filter events from speed-trap checkbox, if necessary (6). If the checkbox is checked only the first detected speed value is registered, while other values are ignored until the delay expires or until the LP number is recognized.
  7. Click Apply (7).

The joint operation of the LPR channel and Radar modules is complete.