Documentation for Detector Pack 2.7. Documentation for other versions of Detector Pack is available too.

Previous page Configuring the «Sweethearting detection» module  Configuring the «Train detection» module Next page


The Barcode detection module can be configured using the System settings menu, under the Hardware tab, on the Barcode detection control panel, using the Camera settings.

The Barcode detection module is set up as follows:

  1. Go to the Barcode detection control panel.
  2. From the Captioner: drop-down list select the captioner with the help of which result will be displayed in the monitor (1)

  3. In the Skip repeated recognitions, sec: field enter the time in seconds in which the repeated code is recognized (2).

    Note.

    If there are some different barcodes or QR-codes one after another, then recognition is performed instantly. If there are some repeated barcodes then new result will be displayed after time period specified in the settings.

  4. Click Settings (3). The Detection settings window will appear.
  5. Specify the detection surveillance area:
    1. Click the Stop video button to capture the video image (1).
    2. Click the Area of interest button (2).

    3. On the captured video image specify areas to be analyzed. It is possible to add only one area. While attempting to add the second area the first one will be deleted. After area specifying the remaining part of video image will be darkened.

      Note.

      To remove the area click the  button next to the Area of interest button.

    4. Click OK button (3) to save changes and return to the control panel of the Barcode detection.

      Note.

      To return to the control panel of the Barcode detection without saving changes, click Cancel.

  6. On the Barcode detection control panel, click Apply button (4).

Configuring the Barcode detection module is complete.