Previous page Next page


Relay of BioSmart 4 controller is configured on the settings panel of the BioSmart 4 object:

  1. Configure the exit relay of BioSmart 4 controller in the corresponding parameter group:
    1. In the Relay list select the type of relay that will be triggered when walking through (1).
    2. In the Timer field specify time (in milliseconds) of active state of the relay after its triggering (2).
    3. To enable the trigger mode set the On value for the corresponding parameter (3). In this case the relay will change its state after each success access. When the controller is switched on after its power failure, the relay returns to the state it had when power was switched off.
    4. In the corresponding list select the relay locking mode (4).
      Manual mode – locking is activated when the Open button is pushed and inactivated when the Close button is pushed. 
      By timer – locking is activated when the Open button is pushed and inactivated in time period specified in the Timer field (see step 1.2).
  2. Configure the relay control button in the corresponding group of parameters:
    1. In the corresponding list select the entry to which the button is connected (5).
      If the button is disabled, then set the None value. In this case, skip the following steps.
    2. Select the type of relay that triggers when pushing the control button (6).
    3. In the Timer field specify time (in milliseconds) of active state of the relay after pushing the relay control button (7).
  3. Click the Apply button to save all changes.

Relay of BioSmart 4 controller is now configured.

  • No labels