Creation and setting up of exit groups

Setting up exit groups is carried out on setting panel of N1000 group object.  This object is created on the basis of N1000 panel object on Hardware tab of System settings dialog box.

Setting up exit groups is carried out the following way:

1. Go to setting panel of N1000 group object.
   
2. Set address of exit group in the corresponding field (1).
3. Set checkboxes opposite those exits that should be in the group (2).
4. In Impulse setting group set parameters of exit group impulse:
5. In Duration field set the period during which power supply  (impulse) will be given to exit group (3);
6. From the corresponding dropdown list select time zone during which power supply will be given to exit group automatically (4).
7. If it’s necessary set time zone during which there will be no interactions connected with this exit group (5).
8. If it’s necessary select warning group from the corresponding dropdown list (6).
9. If it’s necessary set this group as a special group for exit: set Allow checkbox and select necessary object from the list (7).
10. Click Apply in order to save changes (8).

Setting up exit groups is completed.