Setting up the Vehicle detector parameters

Setting up the Vehicle detector parameters is done in the following way:

1. Go to the Vehicle detector object settings panel.
   

2. From the Camera dropdown list select the Camera object, corresponding to the camera of the Vehicle detector (1).

3. From the Version dropdown list select the required detector's version (2).

   Note.

   Different versions detectors are optimized for performing the different tasks. At the moment of writing the documentation only version 1.0. is available.

4. From the Classification mode dropdown list select the required classification mode of detected vehicles for storing the information to the Vehicle processor database (3).

   Note.

   At the moment of writing the documentation the classification can be performed only by length. This classification setup is made on the Vehicle processor object settings panel. (see section Vehicle's classification setup by length).

5. To save the applied changes click Apply (4).

Setting up the Vehicle detector parameters is completed.