Setting up the vehicles according to the length

If in the module settings there was selected Only vehicles' length in the classification type (see section Setting up the Vehicle detector parameters), the type of detected vehicle (a car, a bus, etc.) will be automatically detected by its length. Data about the detected objects types will be entered in the Vehicle processor database.

There is a possibility to setup the classification of vehicles according to its length.

To setup the classification of vehicles according to its length follow the procedure:

1. Go to the Vehicle processor settings panel.
   
2. Click the Classification setup button.
3. Vehicle classification setup dialog window will be displayed in result.
   
4. In the Classification name field (1) enter the name of vehicle classification that is being setup.
5. To edit the types of vehicles do the following:
   1. In the Type name column (2) enter the required vehicles types 'names.

   2. In the From and To columns (3-4) set the length ranges of vehicles, relating to the corresponding types. The values of range boundaries are entered in meters. The type of detected vehicle will be determined on the basis of this vehicle's length fitting one of the ranges.

      Attention!

      For every pair of vehicles types the length ranges should not intersect.

6. To add a new type of the vehicle to the classification click the Add type button (5) and in the appeared string perform steps 5.a-5.b.
7. To delete a vehicle type from the classification select a string, corresponding to the required type and then click the Delete type button (6).
8. Click Ok to save the changes and close the Vehicle classification setup according to its length dialog window (7).

  Setting up the vehicle classification according to its length is completed.