Setting up the show of results for LP recognition

The LP numbers of passing vehicles are automatically identified and subsequently shown in the LPR channel. On default the identified number is displayed after the vehicle leaves the camera viewing zone.

The Auto-Uragan module can be set to recognize and show the LP number before the vehicle leaves the camera viewing zone.

If the LP number should be shown before the vehicle leaves the viewing zone, do the following:

1. In the System Settings dialog window, open the Hardware tab.
2. In the object tree on the left side of the Hardware tab, select the LPR channel, corresponding to the activated Auto-Uragan, VIT or Carmen modules in the objects tree on the Hardware tab (see Activating the program module, used for identifying the plates section).The settings panel of the selected object will open on the right side of the window.
   
3. Check the Show results before car leaves checkbox. The recognized LP number will be shown before the car actually leaves the viewing zone (more precisely, before the license plate leaves the recognition zone). If the checkbox is unchecked, the result is shown only after the car leaves the zone.

4. Enter the value in the Results show delay field. If this field is set, the results will be shown in the specified number of seconds after the first recognition of the LP number.

   Note.

   This parameter is enabled if the Show results before car leaves checkbox is checked.

5. Enter the value in the Number of recognitions threshold field. If this field is set, the result will be shown after the specified number of reliable recognitions are received. The reliable recognitions counter accumulates and is not cleared in case of temporary zone loss or false recognitions.

   Note.

   This parameter is enabled if the Show results before car leaves checkbox is checked.

6. Click Apply.

 The LP number recognition handling setup is completed.