Documentation for Auto Intellect 5.3. Documentation for other versions of Intellect is available too.

Previous page Next page

The Uragan module can be set to record the video image received by the camera. If this function is enabled, the recording starts automatically when the LPR channel recognizes an LP number. The duration of the recording can also be specified.

Note.

In case of heavy traffic, when subsequent LP numbers are registered in a time period smaller than that specified, the video signal is recorded continuously.

To enable automatic recording functionality and to specify the recording duration, do the following:

  1. In the System Settings dialog window, open the Hardware tab.
  2. Select the LPR channel, corresponding to the activated program module, in the objects tree on the Hardware tab (see Activating the program module, used for identifying the plates section, 2). The settings panel of the selected object will open on the right side of the window.

  3. Check the Auto recording checkbox to enable recording the video upon recognizing an LP number (3).

    Note.

    For correct auto recording when working with the IntLab-Carriage program module specify the Pre-alarm record parameter in the settings panel of the Camera object (see Configuring video in the Pre-alarm record mode).

  4. In the field next to the checkbox, specify for how many seconds the video should be recorded after LP number recognition (4).

    Note.

    Zero (0) in this field means that the recording starts at the moment of LP recognition and continues indefinitely.

  5. Click Apply (5).

The auto recording setup is complete.