Frame processing setup

Half-frame processing is to be performed using the image interlaced scanning (Reduce large resolution check box is set). Receiving the next frame the new one consisting of even rows of the initial frame is processed if the Reduce large resolution check box is set. By default, the LPR channel processes the frame.

The frame processing is not to be performed and the Reduce large resolution is to be unchecked when full resolution is used.

By default, when the Reduce large resolution checkbox is checked, the LPR channel processes the frames in the following way:

If the frame resolution is smaller than the LPR channel requires, it is up-scaled to the required size.
If the frame resolution is larger than the LPR channel requires, it is down-scaled to the required size.

Note.

While using full resolution, the Reduce large resolution checkbox should be necessary checked, otherwise unwanted «rake» effect may be observed.

If the Reduce large resolution checkbox is unchecked, the frames are processed in the following way:

If the frame resolution is smaller than the LPR channel requires, it is up-scaled to the required size.
If the frame resolution is larger than the LPR channel requires, it is processed as it is (with no down-scaling).

Note.

Frame processing setup is given only when AUTO-Uragan, CARMEN-Auto, ARH-Containers, VIT, IntLab, LPR IntelliVision program module is used.

To set the frame processing, do the following:

Go to the LPR channel object settings panel, corresponding to the activated module (see Activating the program module, used for identifying the plates).
Set the Reduce large resolution checkbox (1).
Note
It is recommended to always set the Reduce large resolution checkbox in order to decrease the CPU load.
Click Apply (2).

The frame processing setup is now complete.

Page tree

Documentation for Auto Intellect 5.5. Documentation for other versions of Intellect is available too.