Page History

To set up the Vehicle tracer interface window do the following:

1. Go to the «Vehicle tracer» Vehicle tracer settings panel (Fig. 7.9—8).
   

...

1. Image Added
2. Click Settings... button. The Settings dialog

...

1. Click «Settings button» (Fig. 7.9—8). The «Settings dialog» window will open in result (Fig. 7.9—9).

...

1. .
   Image Added

1. In the «Event's number in the protocol» field (Fig. 7.9—9,

   In the Number of events in protocol field (

   1) enter the maximum number of events that may be displayed in every protocol of the Active monitor component. Updating the protocol, containing the maximum number of events, is performed in a loop: while adding a new event the earlier is deleted.

   Info
   title Note.
   The question is about two protocols (see the document

...

1. The Auto-Intellect

...

1. Software Package: Operator

...

1. 's Guide): The protocol of identified vehicles, containing data about the identified vehicles; The alarms protocol, containing data about the vehicles, for which alarms have been registered.

2. Set the Speed switch (Fig. 7.9—9, 2) to the position, corresponding to the Vehicle's speed unit of measurement? . That is to be displayed in the Vehicle tracer window (km/h or m/h).
3. On default in the Active monitor's   events protocol there are displayed the following data for every vehicle:
   
   1. Video frame;
   2. Identified plate;
   3. Speed;
   4. Plate's recognized;
   5. Date and time of receiving the data;
   6. Alarm's reason (only for alarms).
      In case if in the Active monitor

...

1. 1. events protocol there should be displayed only identified number, name of plate's recognizer, and data and time of receiving the data for every event, set the

...

1. 1. Reduced view of protocol checkbox (

...

1. 1. 3).
2. There is possibility to create additional Active monitor components (see the document «the The Auto-Intellect program complexSoftware Package: Operator guide»'s Guide»). In case if the alarms protocol is displayed only in the main interface component Active monitor, not in the additional ones, set the «Alarm inset Protocol of alarms only in main Active Monitor window «Active monitor»» checkbox (Fig. 7.9—9, 4).
3. On default the number of active monitor additional displayed components is not restricted. In case if only one, last created active monitor component is required to be displayed, set the «Only Only one additional window active monitor» monitor checkbox (Fig. 7.9—9, 5).

4. Click

   «OK»

   OK to save the changes and close the Settings dialog window

   »

   (

   Fig. 7.9—9,

   6).

   Info
   title Note.
   Click Cancel to close the Settings dialog window without saving the changes (

...

1. 7).

   The interface settings of the window Vehicle tracer are completed.