Page History

...

1. Go the Hardware tab in the System Settings dialog (1).
2. In the object tree on the Hardware tab, select the previously created Camera object that corresponds to the video camera for which multistream mode is to be configured (2). The right part of the Hardware tab shows the settings pane for the selected object.
3. On the Camera object's settings pane, go to the Advanced settings tab (3).
   
4. To enable multistream mode, check the Video stream setting box (4). This will display tabs for configuring the camera's video streams (5).

5. By default, all streams are enabled. If it is necessary to disable unused streams, clear the check boxes that correspond to the numbers of the relevant streams (6).

6. Set the Default switch to match the number of the stream that you want to use for displaying video locally and on remote clients (7).

   Info
   title Note.
   This stream is used, for example, to display video on the Video Surveillance Monitor if a default stream has been selected for the camera or for displaying video on the Video Surveillance Monitor of the web server.

7. Set the Video analytics radio button to the number of the stream to be used by sensors (8).

8. Set the Archive

   radio button

   switch to position corresponding to the number of stream that is to be recorded to the archive not upon alarm – the continuous recording is performed (9). 

9. Set the Archive(alarm) switch to position corresponding to the number of stream that is to be

   written

   recorded to the archive upon alarm (

   9)

   10).

   Info
   title Note.
   If different streams are selected for recording to the archive upon alarms and continuous recording, recording is performed non-stop and detection tools are enabled, then upon alarm recording of the current archive fragment is stopped in the continuous recording stream and recording of a new fragment starts in the alarm recording stream. When the alarm ends and after pre-alarm recording the continuous recording with the corresponding stream resumes. If the same stream is selected for recording to the archive upon alarms and continuous recording, then recording of current fragment is not stopped upon alarm.

   Info
   title Note.
   If pre-alarm recording is configured, then when different streams are selected for recording to the archive and continuous recording, some archive recordings overlay as the following video fragment starts before the previous ends.

10. Configure the video streams as follows:
    
    1. Go to the tab that corresponds to the desired video stream (1011).
       
    2. The Purpose field displays a description of how the video stream is used (1112).

    3. Specify the video stream's parameters (1213) (see The Settings panel of the Camera object).

       Note
       title Attention!
       Following video streams are available for Axis cameras: 1. Receiving of H264/MJPEG/MPEG4 video. It is available to specify settings of video stream using the Intellect software package facilities. Settings are specified in the Video stream 1 tab. 2-4. Stream corresponding to “Quality”, “Balanced” and “”Bandwidth” profiles. These profiles configure in the camera web-interface. Video stream 2 corresponds to the “Quality” video stream, Video stream 3 corresponds to the “Balanced” video stream, Video stream 4 corresponds to the “Bandwidth” video stream.

    4. Repeat steps a-d for the remaining video streams.
11. Click the Apply button.

...