Versions Compared

Old Version 2

changes.mady.by.user Sofya Uyutova

Saved on

compared with

New Version 3

changes.mady.by.user Sofya Uyutova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Go to the Hardware tab in the System settings dialog box (1).
  2. Select the Camera object corresponding to the required camera in the objects tree (2). The settings panel for the selected object is displayed on the right of the Hardware tab.
  3. Go to the Basic settings tab on the settings panel of the Camera object (3).
  4. In the Recording frame rate field specify the frame rate of the video to be recorded (4).
  5. In the Hot record rate field specify the frame rate for the alarm hot recording (5).

  6. In the Hot record time field specify the interval in sec during which the video is being recorded at the rate that has been set in the Hot record rate field, from the moment of alarm registration (6).

    Info
    titleNote.
     If there is an end of alarm event while recording in the hot record mode, then recording to the archive will be with the same rate as hot record until the end of specifyied interval.  
  7. Click the Apply button (7).
Info
titleNote.
 Record to If the Recording frame rate parameter (Camera object, Basic settings tab) is set to non-zero, regardless of its value of recording to the archive is performed only by anchor frame frames if the H.264 codec is in use independent from the value of the Recording frame . If the Hot record rate parameter . Record to for H.264 codec is also in use, then the recording to the archive will be performed also only by anchor frames while simultaneous using of the Hot record rate parameter for the H.264 codectoo. If the Recording frame rate parameter is set to 0 or not set, all frames are recorded to the archive.