Page History

Setting up Configure the VIT program module is performed in the following wayas follows:

1. Go to the Hardware tab in the System settings dialog window (1).
2. In the objects tree on the Hardware tab select Select the VIT object, corresponding to the set VIT program module in the objects tree in the Hardware tab (2). The settings panel of the selected object will open on the right of the window.
   Image RemovedImage Added

3. Set the Zooming check box checkbox checked to increase the plate recognizing speed on mega-pixel vedio video cameras without loss of recognizing quality (3).

   Info
   title Note.
   This check box is relevant when the value of the Zone width parameter is more than 150 pixels (see Setting up the LPR channel detector section). The recognizing speed is increasing: 2 times if the value of the Zone width parameter is more than 150 pixels; 4 times if the value of the Zone width parameter is more than 400 pixels; 8 times if the value of the Zone width parameter is more than 800 pixels.

   Set the Consider LP angle checkbox if license plate angle is to be taken into account at recognition

4. Specify maximum recognition streams (4).

5. Set the Deeper image analysis checkbox if enhanced algorithm of image analysis is to be used in order to search and recognize a license plate (5).
6. A threshold for pixel brightness evaluation when converting colored image to black-and-white for analysis can be set in the Binarization threshold of color pixels into black and white field (6).

7. If the value is 0, recognition will be performed in the same stream it was started.

    

   Note
   title Important!
   It is not recommended to specify the value that is more than the number of CPU cores.

8. Perform SDK tweaking if required (5, see VIT module object settings panel).

    

   Note
   title Important!
   SDK tweaking is to be performed only with the help of AxxonSoft specialists!

   A similarity level between LP template and analyzed image can be set in the Minimal percentage of similarity between result and template field in percents (7).
9. Click Apply to save the changes (8).

Setting up the The VIT program module is completednow configured.