Page History

The LP numbers of passing vehicles are automatically identified and subsequently shown in the the LPR channel. On By default the identified number is displayed after the vehicle leaves the camera viewing zone.

The The Auto-Uragan module  module can be set to recognize and show the LP number before the vehicle leaves the camera viewing zone.

If the LP number should be shown before the vehicle leaves the viewing zone, do the following:

1. In the the System Settings dialog  dialog window, open the the Hardware tab  tab (1).
2. In the object tree on the left side of the the Hardware tab tab, select the the LPR channel (2).The settings panel of the selected object will open on the right side of the window.
   
3. Check the the Show results before car leaves checkboxvehicle leave checkbox (3). The recognized LP number will be shown before the car actually leaves the viewing zone (more precisely, before the license plate leaves the recognition zone). If the checkbox is unchecked, the result is shown only after the car leaves the zone.

4. Enter the value in the Results show delay fieldthe Delay of showing results field (4). If this field is set, the results will be shown in the specified number of seconds after the first recognition of the LP number.

   Info
   title Note.
   This parameter is enabled if the Show results before car leaves vehicle leave checkbox is checked.

   
   

5. Enter the recognitions threshold value in the Number of recognitions threshold fieldthe Maximum number of field (5). If this field is set, the result will be shown after the specified number of reliable recognitions are received. The reliable recognitions counter accumulates and is not cleared in case of temporary zone loss or false recognitions.

   Info
   title Note.
   This parameter is enabled if the Show results before car leaves vehicle leave checkbox is checked.

   
   

6. Click ApplyClick Apply (6).

 The LP number recognition handling setup is completedThe LP recognition results display is set up.