Versions Compared

Old Version 3

changes.mady.by.user Vadim Belyakov

Saved on

compared with

New Version Current

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Rus

The LP numbers of passing vehicles are automatically identified and subsequently shown in the LPR channel.

...

By default the identified number is displayed after the vehicle leaves the camera viewing zone.

Info
titleNote.

This setting is specified only if Auto-Uragan, VIT or CARMEN-Auto software modules are in use.

...

  1. In the System Settings dialog window, open the Hardware tab (1).
  2. In the object tree on the left side of the Hardware tab, select the LPR channel (2).The settings panel of the selected object will open on the right side of the window.
  3. Check the Show results before car leaves checkboxvehicle leave checkbox (3). The recognized LP number will be shown before the car actually leaves the viewing zone (more precisely, before the license plate leaves the recognition zone). If the checkbox is unchecked, the result is shown only after the car leaves the zone.

  4. Enter the value in the Results show delay field Delay of showing results field (4). If this field is set, the results will be shown in the specified number of seconds after the first recognition of the LP number.

    Info
    titleNote.

    This parameter is enabled if the Show results before car leaves vehicle leave checkbox is checked.


  5. Enter the recognitions threshold value in the Number Maximum number of recognitions thresholdfield (5). If this field is set, the result will be shown after the specified number of reliable recognitions are received. The reliable recognitions counter accumulates and is not cleared in case of temporary zone loss or false recognitions.

    Info
    titleNote.

    This parameter is enabled if the Show results before car leaves vehicle leave checkbox is checked.


  6. Click Apply (6).
Info
titleNote.

If both fields (Results display delay and Number of recognitions threshold) Delay of showing results and Maximum number of fields are set, the results will be shown upon the event that occurs first (either the time delay elapses, or the number of recognitions is reached). If the values of these parameters are set to 0 or not set at all, then these parameters are not taken into account, and the LP recognition results will be shown after the car leaves the viewing zone.


Info
titleNote.

Show results before car leaves, Results display delay and Number of recognition threshold vehicle leave, Delay of showing results and Maximum number of parameters don't work with the Parking mode.

 The LP number recognition handling setup is completedrecognition results display is set up.