Page History

...

1. Go to the Vehicle processor settings panel.
   Image Modified

2. To enable the mode of imitating the virtual loop set the Virtual loop checkbox (1). The result of this module operation is retranslating the events of vehicles passing in and out from the detection zone, registered by Vehicle detector module. On default the events are retranslated without storing in the Vehicle processor database. To enable storing the events to the database, one should perform step 3.

   Info
   title Note.
   Vehicle's speed will be displayed in the Add. info column of the Event viewer interface object if the Virtual loop checkbox is set.

   
   

3. To enable the mode of gathering and storing vehicles information to the Vehicle processor database set the Collect data checkbox (2).

4. To enable the fixation mode and storing the incidents in the vehicle to the Vehicle processor database set the Register incidents checkbox (3).

   Info
   title Note.
   At the moment of writing the documentation only the Meeting of traffic incidents are fixed.

   
   

5. To enable the mode of vehicles turn's length calculation set the Queue length checkbox. The result of this mode operation is the events registrations with data concerning the length of vehicles' turn. On default events are registered without storing in the Vehicle processor database (4). To enable storing the events to the database, one should perform step 3.
6. From the Access: dropdown list select the Area object, corresponding to the entrance area to the detection zone where the Length of turn is calculated (5).
7. From the Exit dropdown list select the Area object, corresponding to the exit area from the detection zone where the Length of turn is calculated) (6).
8. Click Apply to save the changes (7).

...