Page History

...

If the LP number should be shown before the vehicle leaves the viewing zone, do the following:

1. In the System Settings dialog window, open the Hardware tab (1).
2. In the object tree on the left side of the Hardware tab, select the Go to the LPR channel object settings panel (2).The settings panel of the selected object will open on the right side of the window.
   , corresponding to the activated module (see Activating the program module, used for identifying the plates section).
3. Check the Show results before vehicle leave checkbox (3). The recognized LP number will be shown before the car actually leaves the viewing zone (more precisely, before the license plate leaves the recognition zone). If the checkbox is unchecked, the result is shown only after the car leaves the zone.

4. Enter the value in In the Delay of showing results field (4). If this field is set, specify the results will be shown in the specified number of seconds after the first recognition of the LP numbertime in seconds, after which the recognition result will be displayed. This period of time starts after the first LP recognition.

   Info
   title Note.
   This parameter is enabled if the Show results before vehicle leave checkbox is checked.

   
   

5. Enter the recognitions threshold value in In the Maximum number of field (5). If this field is set, the result will be shown after the specified , specify the number of reliable recognitions are received. The reliable recognitions counter accumulates license plate recognitions, upon reaching which the recognition result will be displayed. The recognition number counter is cumulative and is not cleared reset in case of temporary loss of a given zone loss or false recognitions.

   Info
   title Note.
   This parameter is enabled if the Show results before vehicle leave checkbox is checked.

   
   

6. Click Apply (6).

...