Page History

The Uragan  LPR channel module can operate together with the LPR channel.

...

 Speed traps server module. In this case, each vehicle recognized by the LPR channel module is compared to the speed value set specified in the Speed-trap device.

To set up the joint operation of the LPR channel and Radar Speed traps server, do the following:

1. Go to the LPR channel object settings panel (2), corresponding to the activated module activated Auto-Uragan, CARMEN-Auto or VIT program module (see Activating the program module, used for identifying the plates section).
2. Go to the Speed camera settings tab (31).
   
3. In the Speed camera settings drop-down list (2), select the Speed-trap object  Speed traps server object representing the speed-trap device directed at the same lane as the LPR channel camera (4).

4. In the Synchronization time field (3), enter the time period in milliseconds that it takes the vehicle to drive from the spot of speed detection by the Radar speed-trap to the viewing zone of the LPR channel recognition video camera (5).

   Info
   title Note.
   Synchronization time is needed to synchronize the operation of the Radar and Speed traps server and the LPR channel modules.

   
   

5. Check Set the Filter events from speed -trap checkbox, if necessary (6). If the checkbox is checked camera checkbox (4) if it is necessary to record only the first speed value detected speed value is registeredby the speed-trap device, while other values are ignored until the delay expires or until the LP number is recognizedrecognize.
6. Click Apply (75).

The joint operation of the LPR channel and Radar and Speed traps server modules is complete.