Page History

User fingerprints are added to the system on the settings panel of the BioSmart2 object.

To add fingerprints, do the following:

1. Click the Control fingerprints button on the settings panel of the BioSmart2 object.
   Image RemovedImage Added
2. Find a user by the ID or surname by clicking the Find button (1).
   Image Added
3. Select the user (2) and click the Add fingerprint button (3).
4. Select an available fingerprint reader and click the Select reader button (1-2).
   
5. A dialog box showing fingerprint reading status opens.
   Image Modified
6. Put a finger on the reader and hold it until you hear a beep. When reading of the fingerprint is finished, a number of fingerprints read is displayed in the Fingerprint reading dialog box. A dialog box instructing to put the finger to the reader again opens.
   

7. Put the same finger on the reader and hold it until you hear a beep. Click Yes in the opened dialog box to save fingerprints or No to cancel input.
   

   Info
   title Note.
   Two copies of the same fingerprint, i.e. a comparison pair, are read per one cycle (steps 6-7). A Biosmart controller allows 5 comparison pairs per user.

   
   

8. The number of fingerprints added for the selected user will be displayed in the Control fingerprints box.
   

9. Add fingerprints for all required users.

   Info
   title Note.
   To delete fingerprints, select the user in the box and click the Delete fingerprints button.

   Image Modified

10. Write the VMS data to controller (see Writing the VMS data to controller section). If thethe Send VMS data dynamically checkbox is set checked, then there is no need to perform this action.

...