Page History

Adding fingerprints of the Access Manager users via the Suprema RealScan control reader is performed as follows:

1. Open Go to adding biometric data in the Access Manager window (see Starting and stopping the Access Manager module). Go to user editing (see Going to user editing).
2. Right-click the user's photo and select Extensions -> (Edit Fingerprints) Suprema RealScan.
3. window (see Adding biometric parameters).
4. Select the (Fingerprint Authentication) Suprema RealScan extension that corresponds to the Suprema RealScan control reader.
5. The Suprema. Edit fingerprints dialog box will open. To add a new fingerprint, click the Add button in the Suprema. Edit fingerprints window.
   
   The Suprema. Capture fingerprints window will open.
   
6. From the Mode drop-down list (1) select the fingerprint capture mode:
   • One finger - reading a single fingerprint.
   • Two fingers - reading two fingerprints.
   • Two thumb fingers - reading two thumb fingerprints.
   • Left four fingers - reading fingerprints of four fingers of the left hand.
   • Right four fingers - reading fingerprints of four fingers of the right hand.
   • Ten fingers - reading 10 fingerprints.
   • Left palm -  reading reading the left handprintpalm print.
   • Right palm - reading the right handprintpalm print.
   • One roll finger - reading a single fingerprint with an offset.
7. From the Quality drop-down list (2) select the fingerprint capture quality:
   
   • 20 (Weak) - low quality.
   • 40 (Moderate) - average quality (default).
   • 60 (Strong) - high quality.
   • 80 (Strongest) - the highest quality.

8. To start capturing fingerprints, click the Start capturing button (3) and follow the instructions displayed at the top of the Suprema. Capture fingerprints window.

   Info
   title Note
   To capture fingerprints, each finger or group of fingers should be placed on the reader twice with 5 seconds delay after pressing the Start capturing button and after the first capture.

   
   

9. After the fingerprint capture is completed, select the type of scanned finger for each fingerprint in the drop-down list (1):

   • Undefined - undefined.
   • Left thumb - thumb of the left hand.
   • Left index finger - index finger of the left hand.
   • Left middle finger - middle finger of the left hand.
   • Left ring finger - ring finger of the left hand.
   • Left little finger - little finger of the left hand.
   • Right thumb - thumb of the right hand.
   • Right index finger - index finger of the right hand.
   • Right middle finger - middle finger of the right hand.
   • Right ring finger - ring finger of the right hand.
   • Right little finger - little finger of the right hand.

   

10. Unset Uncheck the Add check box (2) if it is not necessary to add the fingerprint to the user.

11. Click OK to save the result.

12. The captured fingerprints will be displayed in the Suprema. Edit fingerprints window.
    

13. To remove one fingerprint, select it and click Remove.

    Info
    title Note
    To remove all fingerprints, click Remove all.

    
    

14. To mark a fingerprint as captured "Under duress", select it and click the [Duress] button.

    Info
    title Note
    As a result, an a silent alarm will be generated when reading this fingerprint.

    
    

15. To move a fingerprint up or down in the list, select it and click the Up or Down button.Click Ok and then save the user settings

16. To finish entering fingerprints, click OK.

Capturing the fingerprints of the Access Manager users with Suprema RealScan is complete.