Page History

Verification of user authentication using the Suprema RealScan control reader is performed as follows:

1. Open Go to adding biometric data in the Access Manager window (see Starting and stopping the Access Manager module).
2. Go to user editing (see Going to user editing).
3. window (see Adding biometric parameters).
4. Right-click the user's photo and select Extensions -> Select the (Fingerprint Authentication) Suprema RealScan extension that corresponds to the Suprema RealScan control reader.
5. The Suprema. Autentification window will open.
   
6. From theQualitythe Quality drop-down list (1) select thefingerprint the fingerprint capture quality:
   
   • 20 (Weak) - low quality.
   • 40 (Moderate) - average quality (default).
   • 60 (Strong) - high quality.
   • 80 (Strongest) - the highest quality.

7. To start capturing fingerprints, click the Start capturing button (2) and follow the instructions displayed at the top of the Suprema. Autentification window.

   Info
   title Note
   The finger should be attached with 5 seconds delay after clicking the Start capturing button.

   
   

8. As a result, if there are no fingerprint matches, the Matches not found message will be displayed at the top of the Suprema. Autentification window.
    

   If fingerprint matches are found, then the Matches found message will be displayed at the top of the Suprema. Autentification window.
   

9. To open the door for entrance, click the Access in button (1).

10. To open the door for exit, click the Access out button (2).

11. To close the Suprema. Autentification window, click Cancel (3).

...