Page History

...

Configuring the Video / Audio

Image Modified

1. Set the Video switch (2) to the position corresponding to the video camera used for calls:

   1. Off — the video is not used during the call.

   2. SIP camera — a SIP-device camera connected via the SIP protocol is used. If the wrong device is selected by default in the Camera (2) drop-down list, change the selection. The corresponding Camera object may not be created in the Intellect objects tree at this step; in this case, it will be created automatically after clicking the Apply button.

   3. Other — any other camera from the Intellect hardware tree is used. In this case, select the name of the required Camera object from the Camera drop-down list (2).

2. Set the Audio switch (4) to the position corresponding to the microphone used for calls:

   1. Off — the audio is not used during the call.

   2. On — the microphone of the SIP-device is used as shown in the Microphone information field (5). The corresponding Microphone object may not be created in the Intellect objects tree at this step; in this case, it will be created automatically after clicking the Apply button.

3. Click Apply (6).

...

1. Go to the Relay tab on the settings panel of the SIP-device object (1).
   Image Modified
2. Select the type from the DTMF type drop-down list (2):
   1. in_band – the signal is transmitted as normal sound in an audio stream.
   2. rtp_nte sip_info – signals are transmitted via RTP separately from the voice streamin the SIP INFO message.
   3. sip_info notify – signals are transmitted in the SIP INFO NOTIFY message.
   4. in_band – the signal is transmitted as normal sound in an audio stream.
   5. http_bas – signals are transmitted over HTTP. When this type of tone is selected, the Device connection settings group of settings (3) becomes available to specify the Login, Password and IP address of the SIP device. If the port is different from the actual one (for example, it's 8180, not 80), then specify the port in the IP address field also. If the IP address field is left blank, then the IP address will be taken from the session, and the port will be presumed to be 80sip_notify – signals are transmitted in the SIP NOTIFY message.
3. In the Signal duration, ms field set the time period in milliseconds during which the command is to be sent(3). This value is applied if duration is not set for a specific command.
4. In the Name field, enter the name of the command displayed on the SIP panel (4).
5. In the Code field, enter the unique command code (5).
6. Click Apply (6).
7. The corresponding Relay object (7) will be created in the Intellect hardware tree.

...