Page History

...

Configuring the SIP-device

Before you start configuring the SIP-device connection to Intellect, it is necessary to configure the device itself. Each SIP-device is configured individually according to the manufacturer's documentation, however, it is always necessary to perform the following basic steps:

1. Specify the IP address of the Intellect server that acts as a SIP server.
2. Check or specify the SIP-device identification number (the number used for calls).
3. Set the password for the SIP-server connection.
4. If the SIP-device does not support dialing from the keyboard and has only one button for calling the concierge, it is necessary to configure this button to call the Intellect operator (see Configuring SIP-operators of the Intellect's SIP server).

Configuring the SIP-device connection to Intellect

The SIP-devices connection to the Intellect SIP-server is configured as follows:

1. Create a SIP-device object based on the SIP-terminal object of the SIP-server type (1).
   
2. In the User ID field (1), enter the SIP-device identification number, i.e. the number to call it.

3. In the Device IP address field (2), enter the SIP-device IP address. If you are not going to send data to the SIP-device, this field is optional.

4. In the Password field (3), enter the password specified on the SIP-device. The SIP-device with the specified identifier will be connected to Intellect only if the passwords on the device and in Intellect are identical.

5. The State field (4) indicates the current status of the SIP-device.
6. From the Device type drop-down list (5), select the icon type used to display the device on the Map.
7. From the Device priority drop-down list (6), select the priority of calls from this device when displayed on the SIP panel. The lower the number, the higher the priority and, hence, the higher the call is displayed in the list. If the field is left blank, the priority is considered minimal. Calls from devices with the same priority will be sorted by the time of the call.
8. Click Apply (7).

Configuring the Video / Audio

Configure the SIP-device's video and audio in the following order:

1. Go to the Video / Audio tab (1) on the settings panel of the SIP-device object.
   

2. Set the Video switch (2) to the position corresponding to the video camera used for calls:

   1. Off — the video is not used during the call.

   2. SIP camera — a SIP-device camera connected via the SIP protocol is used. If the wrong device is selected by default in the Camera (3) drop-down list, change the selection. The corresponding Camera object may not be created in the Intellect objects tree at this step; in this case, it will be created automatically after clicking the Apply button.

   3. Other — any other camera from the Intellect hardware tree is used. In this case, select the name of the required Camera object from the Camera drop-down list (3).

3. Set the Audio switch (4) to the position corresponding to the microphone used for calls:

   1. Off — the audio is not used during the call.

   2. On — when making a call, the microphone of the SIP-device, displayed in the Microphone information field (5), is used. The corresponding Microphone object may not be created in the Intellect objects tree at this step; in this case it will be created automatically after clicking the Apply button.

4. Click Apply (6).

   Info
   title Note
   If necessary, the pre-configured missing Camera and Microphone objects will be automatically created in the Intellect objects tree.

   
   

Configuring the tone DTMF commands

The setting of sending tone messages to a SIP-device (for example, a combination for opening a door) is carried out by setting the relay.

...