Page History

...

To configure the View camera macro, it is necessarydo the following:

1. Select the camera to be displayed (1) or Camera that initiated command execution (see Configuring filters for event-driven macros). You can select a group of cameras for the Switch to archive mode (see i. step 2).
   

   Note
   title Attention!
   If the macro was triggered by a sensor or a relay (see Configuring filters for event-driven macros) that are not associated with the camera, the action will not be triggered.

   

2. Select the display mode (2).

   Display mode	Description
   Select camera	The camera is highlighted on the layout
   Zoom in camera	The camera is highlighted on the layout, the viewing tile takes up 98% of the screen
   Zoom in and show map	The camera is highlighted on the layout, the viewing tile takes up 50% of the screen, the map under the tile shows the camera
   Switch to immersion mode	Immersive mode is on, the viewing tile takes up 50% of the screen
   Switch to archive mode	The camera is highlighted on the layout and it is in archive mode. If a group of cameras is specified, then a layout is created with all the cameras in archive mode
   Mark camera	The camera is added and highlighted on the Selected Marked cameras layout (see Creating special layouts)
   Unmark camera	The camera is deleted from the Selected Marked cameras layout (see Creating special layouts)

   
   

3. Specify the number of the monitor on which the camera should be displayed (3).

4. Select the user roles, for which this macro will be available (4).

...