Page History

...

To make a call from the panel, select a number in the address book or dial the number manually, and then click one of the following buttons:

•  — — to start a call with video and audio.  If If the operator's camera, the microphone and the operator speaker were selected at the stage of system configuration , stage and the SIP-device supports the corresponding function, then video and audio from the camera , as well as and audio from the operator 's microphone , will be transmitted to the device.
• — to start only an audio calla call with audio only.

In both cases, both video and audio are transmitted from the SIP-device, but in the second case, the video stream from the operator’s operator camera is not transmitted to the device.

If the option to call unknown subscribers is enabled, then when you call an unknown number, it will be displayed as "Unknown number + #number".:

If an unknown number exists, the call will be successful, if not, the call will be ended.

During the call, the SIP Panel window -panel window will be displayed on top of all windows and will look like this:

...

The buttons at the bottom of the panel provide manage the call control:

 — — Enable/disable the operator 's camera.

 — — Enable/disable the operator’s operator microphone.

 — — Enable/disable the operator’s operator speaker.

 — — Hold the call. A window The Incoming tab will open with a list of all incoming calls that can be accepted/resumed using the buttons buttons (with the video from the operator) and  (without the video from the operator):

Image Removed

Image Added

The calls Calls in the list are sorted by the SIP-operator operators and SIP-device priority specified during devices priority, that was set at the system setupconfiguration stage. If several operators and or devices have the same priority, the calls from them are sorted by the call receiving time. By default, the new calls are added to the top of the list, however, but the sorting order can be changed during the system setup configuration, so that the new calls are added to the end of the list regardless of the operators and devices priority (see Advanced settings of the SIP-panel interface object).

A The window with the call list window is displayed on top of all windows when making during a call and holding a calla call on hold.

 — — Display/hide the tone dialing panel in the tone mode. This panel allows displays the use of commands macros added while configuring the SIP-device (see Configuring SIP-devices of the Intellect's SIP server).

 — End the call.