Page History

...

1. Go to the LPR channel object settings panel, corresponding to the activated module (see Activating the software module used for identifying the plates section).
   
2. Check the Search area checkbox (1) to enable specifying the search area borders.
3. In the Left, Top, Right, and Bottom fields (2), specify the required values. These values correspond to the search area borders percentage of the full frame size.
   To specify the search area borders using the mouse, do the following:
   1. Click the Image Removed the Image Added (3) button. The Search area border, % window will appear. In this window, do the following:
      Image RemovedImage Added
      1. left-click and hold the mouse button on the video image at one of the corners of the supposed search area;
      2. keep the mouse button pressed and drag the pointer across the supposed search area to the opposite corner;

      3. release the mouse button;

      4. click the OK to save the selected area.

         Info
         title Note
         With the use of VIT software module, you can specify search area borders of any shape.

         Image RemovedImage Added

         To specify non-rectangular search area borders, set the anchor points of the required shape with the left mouse button. After you set the last anchor point, click the right mouse button, and the shape will automatically close.

4. Click Apply (4).

...