Page History

...

1. Go to the Train detection control settings panel.
   
2. Click the Settings button. The Detection settings windows will open.
3. Specify the surveillance area on the video image:
   1. Click the Stop video button to capture the video image (1).
      
   2. Click the Area of interest button (2).

   3. On the captured video image (3), sequentially specify nodal points of area to be analyzed by clicking the left mouse button (4). It is possible to add only one area.  While Wheen attempting to add the second area, the first one will be deleted. After area specifying, the remaining part of video image will be darkened.
      

      Info
      title Note.
      To remove the area, click the button next to the Area of interest button.

      
      

      Info
      title Note.
      The surveillance area should The surveillance territory is to be specified in such a way as to be no any motion in it except of the train motionthat except for the train movement, there is no other movement.

      
      

      Note
      title Attention!
      Setting the Area of interest is a mandatory requirement for the detection module operation.

      
      

4. Go to the Parameters tab (5) and do the following:
    
   1. In theFrames processed per second [0.016,100] field (6), set the number of frames per second that will be processed by the detection tool.

   2. Click the OK button to save to save the changes and return to the control settings panel of the the Train detection (7).

      Info
      title Note.
      To return to the control settings panel of the Train detection without saving the changes, click the Cancel button.

      
      

5. Click Click the Apply button on the Train detection control settings panel.

Configuring the Train detection module is complete.