Page History

...

The Modbus Coil Register is configured as follows:

1. Go to the settings panel of the Modbus Coil Register object settings panel which that is created on the basis of the Modbus Device object.
   Image Modified

2. In the Address field (1), enter the Coil Register address in the register map of this device.

   Info
   title Note
   The register registers map is provided by the manufacturer. The register address is always less than the register number by the vendor 1. The register address is specified in the settings.

   
   

3. From the Value drop-down list (2), select the coil register value: Reset or Set.
4. Click the Read value button (3) if it is necessary to read the device register.
5. Click the Write value button (4) if it is necessary to specify the selected value to the device register.
6. Set the Auto update checkbox (5) if it is necessary to automatically read the register values with the interval specified on the Modbus Device object settings panel.
7. From the Rule drop-down list (6), select the rule to which this Register will oberegister will obey (see Configuring the Modbus Rule).
8. Set the Value change checkbox (7) if it is not necessary to display the events on the register value change in the Event LogViewer. 

9. Uncheck Clear the Indicator change checkbox (8) if it is necessary to allow displaying of the register values in the plain text on the map.

   Note
   title Attention!
   Value change of this parameter will be applied after restarting the ACFA PSIM Server.

   
   

10. Set the Config event checkbox (9) if it is not necessary to display the events in the Event Protocol when Viewer when the rule is triggered.
11. Click the Apply button (10) to save the changes.

...