Go to documentation repository
Page History
Associating AIM reader commands with terms allows changing term value on corresponding command from reader.
| Note | ||
|---|---|---|
| ||
The commands are executed in the Card and PIN reader mode only. In other modes, commands are not executed (see 1 on in the picture figure below). Most of the reader commands are only supported for AP-500 reader. The usual reader with a keyboard support PIN+10 and PIN+20 commands (2 and 3 commands, correspondingly). |
To enter a command using AP-500 reader, present a card, then press Cmd, enter a command number and press <Enter>. The even command sets corresponding term to TRUE, the odd command sets it to FALSE.
Correspondingly, when PIN+10 is entered, the term assotiated with 2 and 3 commands will be set to TRUE, when PIN+20 is entered, it will be set to FALSE.
| Info | ||
|---|---|---|
| ||
PIN+10 and PIN+20 means that 10 or 20 is added to the PIN number, correspondingly. For example, if a user has PIN - code 8080, then PIN+10 = 8090. The user will have to enter 8090 to set corresponding term to TRUE. |
Assigning AIM reader commands with terms is performed as follows:
- Go to the Apollo AIM Reader object settings panel.
- Click Configure IV (2).
- The Connection with variables configuration dialog box opens.
- In the drop-down list in the Internal variable column, select the Apollo Internal Variable object corresponding to the variable whose the term of which the command from the reader should change (1).
- In the Internal variable drop IV term drop-down list, select the Apollo Internal Variable object Term object corresponding to the required internal variable (2).
- Click the OK button (3).
- Click the Apply button (3).
- To save the changes to the controller, write configuration to hardware.
...
Overview
Content Tools