Page History

By default, the LPR channel scans the whole video image received from the camera for the LP number. To decrease the CPU load on the Server, specify a smaller area where the LP should must be searched for, can be specified.

...

1. Manual entry of the area coordinates.
2. Setting Specifying the borders on the video image using the mouse.

To manually enter specify the exact values of the search area borders, do the following:

1. Go to the settings panel of the LPR channel object settings panel, corresponding to the activated module module (see Activating the software module used for identifying the plates).
   
2. Set the Search area checkbox (1) to enable specifying the search area borders.
3. In the Left, Top, Right, and Bottom fields (2), specify the required values of the search area borders. These values correspond to the search area borders percentage of the full frame size of the surveillance window.
   To specify the search area borders using the mouse, do the following:
   1. Click the  (3) button. The Search area border, % window will appear. In this window, do the following:
      
      1. left-click and hold the mouse button on the video image at one of the corners of the supposed search area;
      2. keep the mouse button pressed and drag the pointer across the supposed search area to the opposite corner;

      3. release the mouse button;

      4. click the OK button to save the selected area.

         Info
         title Note
         If you useVT or RR software modules, you can specify search area borders of any shape.

         

         To specify non-rectangular search area borders, set the anchor points of the required shape with the left mouse button. After you set the last anchor point, click the right mouse button, and the shape will automatically close.

4. Click the Apply button (4).

...