Page History

The LP numbers of passing vehicles are automatically identified and subsequently shown displayed in the Vehicle Tracer interface window. By default, the identified number is displayed after the vehicle leaves the camera viewing zoneFOV.

It is possible to display the vehicle number on the screen before the vehicle leaves the frame only if you use the AUTO-Uragan, AR-Auto, RR(including the RR vendor and model recognizer module) software modules are used.

If To set up the LP number should be shown before the vehicle leaves the viewing zonedisplay of LP recognition results, do the following:

1. Go to the Settings of LP processing tab on the  settings panel of the LPR channel object settings panel, corresponding to the activated module module (see Activating the program module, used for identifying the plates).
   
   
2. Set the Display result before vehicle leaves checkbox (1) to show the result before the car actually leaves the viewing zone frame (more precisely, before the license plate leaves the recognition zone). If the checkbox is not set, the result will be shown only after the car actually leaves the zoneframe.

3. In the Result display delay field (2), specify the time in seconds, after which the recognition result will be displayed. This period of time starts after the first LP recognition.

   Info
   title Note
   This parameter is enabled if the Display result before vehicle leaves checkbox is set.

   
   

4. In the Recognition number threshold field (3), specify the number of reliable license plate recognitions, upon reaching which the recognition result will be displayed. The recognition number counter is cumulative and is not reset in case of temporary loss of a given zone or false recognitions.

   Info
   title Note
   This parameter is enabled if the Display result before vehicle leaves checkbox is set.

   
   

5. Click the Apply button (4).

The LP recognition results display is set up.

...