Versions Compared

Old Version 1

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Door control modules of the Galaxy Dimension v.2 control panel are configured in the settings panel of the GD DCM object. This object is created from the Galaxy Dimension v.2 object on the Hardware tab of the System settings dialog box.

Image Removed

The Galaxy Dimension v.2 control modules are configured as followsYou can create the GD DCM object on the basis of the Galaxy Dimension Panel object. To configure the GD DCM object, do the following:

  1. Go to the settings panel of the GD DCM object.
    Image RemovedImage Added
  2. From the Address drop drop-down list, select the address displayed for the specific control module into in the operator’s menu of the operator of the Galaxy Dimension v.2 control panel (1).Panel.
  3. Set the PIN code confirmation checkbox if it's required checkbox to confirm operations using a PIN code (2).
  4. Click the Apply button to save the changes.
  5. Repeat steps 1-4 for all control modules of the panel.

Configuration of the Galaxy Dimension v.2 control modules Dimension door control module is completed.