Versions Compared

Old Version 8

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 9

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Configuring the parameters of the detection tool

Note
titleAttention!

When a recumbent person is facing the camera or away from the camera, the correct operation of the detection tool isn't guaranteed.

To configure the Person Down Detection, do the following:

  1. Create Pose Detection (see Configuring Pose Detection).
  2. Below the Pose Detection, click Create… → Person Down Detection.

By default, the Person Down Detection triggers if a recumbent person is detected in the specified area.

If necessary, you can change the detection tool parameters. The list of parameters is given in the table:

ParameterValueDescription
Other
EnableYesThe detection tool is enabled by default. To disable the detection tool, select the No value
No
NamePerson Down DetectionEnter the detection tool name or leave the default name
TypePerson Down DetectionName of the detection tool type (non-editable field)
Basic settings
Number of measurements in a row to trigger detection2Specify the minimum number of frames with the corresponding pose or behavior for the detection tool to trigger. The value must be in the range [1, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false alarms, but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases the probability of false alarms

To save the parameters of the detection tool, click the Apply  button. To cancel the changes, click the Cancel  button.

Configuring the frame perspective 

For the Person Down Detection operation, you must configure the frame perspective first.

...