Versions Compared

Old Version 3

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 4

changes.mady.by.user Darya Andryieuskaya

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Configuring the parameters of the detection tool

To configure the Handrail holding detection, do the following:

  1. Create Pose Detection (see Configuring the Pose Detection).
  2. Below the Pose Detection, click Create… → Handrail holding detection.

If necessary, you can change the detection tool parameters. The list of parameters is given in the table:

ParameterValueDescription
Other
EnableYesThe detection tool is enabled by default. To disable the detection tool, select the No value
No
NameHandrail holding detectionEnter the detection tool name or leave the default name
TypeHandrail holding detectionName of the detection tool type (non-editable field)
Basic settings
Number of measurements in a row to trigger detection2Specify the minimum number of frames with the corresponding pose or behavior for the detection tool to trigger. The value must be in the range [1, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false alarms, but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases the probability of false alarms

To save the parameters of the detection tool, click the Apply Image Modified button. To cancel the changes, click the Cancel  button.

Configuring the area for detection

...