Versions Compared

Old Version 10

changes.mady.by.user Darya Andryieuskaya

Saved on

compared with

New Version 11

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width50%
Panel
borderColor#CCCCCC
bgColor#FFFFFF
titleBGColor#F0F0F0
borderStylesolid
titleOn the page:

Table of Contents


Column


Configuring the parameters of the detection tool

Note
titleAttention!

When a recumbent person is facing the a camera or away from the a camera, the correct operation of the detection tool isn't guaranteed.

...

  1. Create Pose Detection (see Configuring the Pose Detection).
  2. Below the Pose Detection, click Create… → Person Down Detection.

By default, the Person Down Detection triggers generates an event if a recumbent person is detected in the specified area.

...

ParameterValueDescription
Other
EnableYesThe detection tool is enabled by default. To disable the detection tool, select the No value
No
NamePerson Down DetectionEnter the detection tool name or leave the default name
TypePerson Down DetectionName of the detection tool type (non-editable field)
Basic settings
Number of measurements in a row to trigger detection2Specify the minimum number of frames with the corresponding pose or behavior for the detection tool to triggergenerate an event. The value must be in the range [1, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false alarmsevents, but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases but increases the probability of false alarmsevents

To save the parameters of the detection tool, click the Apply  button. To cancel the changes, click the Cancel  button.

...

  1. In the preview window, click the  button.
  2. Specify the size of the same person in different parts of the frame by eye. To create a leveling rod, left-click the video image to add two anchor points. You must set at least three leveling rods. The size of the leveling rod must be about the average height of a person at this part of the frame. You can resize the rod by stretching its anchor points . You can move it on screen by dragging and dropping.

    Note
    titleAttention!

    When you set up leveling rods, the following conditions must be met:

    • the rods that are located at the same distance from the camera lens, must be of the same size;
    • the feet of the rods must be located on the same surface (for example, floor);

    • in complex scenes, we recommend adding more than three rods to increase the accuracy of the detection;

    • in the parts of the frame where the lens vertical distortion is observed, the rods must be parallel to the nearest vertical objects (for example, door, wardrobe);

    • if you add only three leveling rods to a scene, you cannot remove them from the scene, you can resize them and change their location;
    • if you add more than three leveling rods to a scene, you can resize them and change their location, and remove them from the scene;
    • for portrait-oriented scenes (such as corridor, shopping aisle, warehouse aisle, and so on), the arrangement of the rods must form triangles.
    Info
    titleNote
    • For convenience of configuration, you can "freeze" the frame. Click the  button. To cancel the action, click this button again.
    • The area for detection is displayed by default. To hide it, click the  button. To cancel the action, click this button again.
    • To delete a rod, click the  button.

  3. Click the Apply button.