Versions Compared

Old Version 2

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Section


Column
width50%


Panel
borderColor#CCCCCC
bgColor#FFFFFF
titleBGColor#F0F0F0
borderStylesolid
titleOn the page:
Table of Contents



Column
 


Network settings of the Web Server 2.0 module are set via the start_86.bat or start_64.bat file (depending on whether the 32-bit or 64-bit version of the Web Server 2.0 module runs). The files are in the <Axxon PSIM installation directory>\Modules\Jetty folder. Apart from the network settings the files provide run parameters such as allocated memory etc. Do not change those parameters.

...

Changing the network interface for the Web Server 2.0 module is complete.

Changing the port used by the Web Server 2.0 module

Web Server 2.0 uses 8085 port by default. If this port is already taken, change the port as follows:

  1. Open the start_86.bat or start_64.bat file.
  2. Set the jetty.port value to the required port number.
  3. Save changes to the start_86.bat or start_64.bat file.
    Info
    titleNote

    To successfully connect via Microsoft Edge browser in Internet Explorer mode over HTTPS, you can select any unused and unblocked port except for port 443. Otherwise, authentication will not be successful.


Changing the port for the Web Server 2.0 module is complete.