Page History

General information

This action allows you to play audio on a server speaker. 

Configuring an action

To configure the action, do the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the  button below start conditions.
5. From the drop-down list, select Notification: Play audio on device.
6. In the Speaker parameter, select the required speaker.
7. In the Audio source parameter, select the audio file you want to play as an audio notification.
   

8. In the Finish after parameter group, specify the condition that stops the notification:

   Condition	Description
   Timer	Only the timer value is set. Notification stops after the set time
   Event filter	One or several events are set, timer is set to 00:00:00. Notification stops when any event from the filter occurs
   Timer + event filter	One or several events are set, timer is set to non-zero. Notification stops after a specified time after any event in the filter has occurred
   Timer + OR checkbox + event filter	One or several events are set, timer is set to non-zero, the OR checkbox is set. In this case, notification stops when whichever condition occurs sooner: either after a specified time or when any event from the filter occurs

   Info
   title Note
   You can set the OR checkbox only if the timer setting is non-zero. An implicit selection of an event is allowed—Last event for condition that initiated execution (see Configuring start conditions). If the event that initiated the execution of the command is the Triggering start from any type of detector, then the end event is the Triggering end from the same detector.

9. Click the Apply button.

Configuration of the Play audio on device action is complete.