Page History

General information

This action starts a slideshow of specific layouts These actions start and stop a specific layout slideshow (see Selection and Slideshow of Layouts) on the selected operator monitor for the assigned specified role. You must configure the conditions to start a macro beforehand (see Configuring filters for event-driven macros).
Image Removed
To configure the Start slideshow action, set the following parameters:

Configuring an action

To configure the Start slideshow action, do the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the Image Added button below start conditions.
5. From the drop-down list, select Monitor: Start slideshow.
   Image Added
6. In the Specify monitor number parameter, select the number of the monitor on which you want to start a slideshow
Select the monitor number from the Specify monitor number drop-down list (1)
7. . If you select a dash (−) when selecting a monitor,
the slideshow will run for
8. a slideshow starts on the active monitor.
Select the number from the Slideshow number drop-down list (2)
9. In the Slideshow number parameter, select the number of a slideshow. The list starts with a zero. For example, Slideshow #1 in the Layouts interface
will have
10. has the number 0.
Select
11. In the Role parameter, select a role for which the macro will
function from the Role drop-down list (3)
12. be executed. If you leave the Role field
empty
13. blank, the macro
will function
14. is executed for all roles that have access to this rule.

The Stop slideshow action is configured in the same way. The macro stops the slideshow being played.
Image Removed

...

1. Click the Apply Image Added button.

Configuration of the Start slideshow action is complete.