Versions Compared

Old Version 4

changes.mady.by.user Alina Luchkina

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

On the Detection Tools Detectors tab, you can check events of detection toolsdetectors. To do this, do the following:

  1. In the list of detection toolsdetectors, select the detection tool detector, which events you want to check.

    Note
    titleAttention!

    The detection tool detector must be enabled and configured.

  2. Reproduce an event upon the occurrence of which the detection tool detector must display the a frame in the event feed:  start start of motion in the frame, camera rotation, sending sound to an audio device, and so on.

If the detection tool detector is configured correctly, frames from the camera that corresponds to the detection tool detector are displayed in the event feed, indicating the time they were received.

Info
titleNote
  • If archive recording isn't configured for the camera that corresponds to the detection tool detector (see Configuring recording to an archive), then there are no frames in the events from the detection tooldetector, because frames are taken from archive recordings.
  • If a detection tool detector has a start and end event, the current state of such a detection tool detector is monitored.


After an event finishes, the Finished caption is displayed below the frame in the event feed.

Checking events of a detection tool detector is complete.