Page History

The Output If a camera has a built-in or pluggable digital output, the Output object is displayed as a child object of the the Camera object in the object tree if a camera has a built-in or pluggable digital output. The total number of Output  Output objects for a camera corresponds to its the number of pluggable digital outputsinputs a camera has. If a device is defined as an IP Serverserver, a relay will be is displayed as a child object of a a Channel object in the object tree (see see Channel).

To configure a the Output object, perform do the following:

1. Go to the Devices tab.
2. Select
a
3. the Output object in the
objects
4. object tree. If necessary, you can change the values of the parameters that are listed in the table:
   

   Parameter	Value	Description
   Other
   Enable

the device (1).
Image Removed

5. 	Yes	By default, the output is disabled. To enable it, select Yes
   	No
   Name	Input	If necessary, enter the output name
   Input/output ID	0 (non-editable field)
   Normal status	Open	From the drop-down list, select the status of the output in which it must be when there is no alarm
   	Closed
   Camera
   Camera	1.Camera	From the drop-down list, select the camera with which you want to bind the output. As a result, the output becomes a child of the selected camera Info title Note If

a

6. the output is a child of

a 

7. the Channel

 object

8. object, then:

1. Turning on a output automatically enables its parent Channel object.
2. Turning off all Input and Output child objects automatically disables their parent Channel object.
9. Enter the name of the output (2).
10. Set the status to which the output will be set when no alarm is present.
    Image Removed
11. Click the Apply button.

12. When you enable the output, the Channel parent object is automatically enabled. When you enable all Input and Output child objects, the Channel parent object is also enabled.

13. Click the Apply button.

As a result, the output is switched to the specified operating The output will then be switched to its assigned work mode.
To check the functioning operation of the output, click the Test button. If the output is configured correctly, its status will briefly change.
Image Removed

If an output is part of an IP server, the sensor settings allow choosing the video camera of the IP server it will be matched to. When you do this, the Output object will appear as the child object of the specified camera in the object tree.

Image Removed