Versions Compared

Old Version 10

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 15

changes.mady.by.user Bahdan Tsiulkou

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Create the Human pose detector (see Configuring the Human pose detector).
  2. Below the Human pose detector, click Create… → People counter.

The People counter counts detector counts the number of people in the specified area using the metadata of the Human pose detector.

...

ParameterValueDescription
Object features
Record mask to archiveYesMask is recorded to the archive by default.  To To disable the parameter, select the the No  valuevalue
No
Other
EnableYesThe detector is enabled by default. To disable the detector, select the No value
No
Name People counterEnter the detector name or leave the default name
TypePeople counterName of the detector type (non-editable field)
Basic settings
Alarm when valueIn rangeSpecify when the detector must generate an event: when the number of people in the specified area is within the set range or out of the range
Out of range
End value of alarm range settings100Specify the range of the number of people in the frame. The value must be in the range [0, 100]
Event interval1

Specify the interval in seconds between two consecutive events of the detector when the number of people in the frame continuously meets the specified conditions. The value must be in the range [1, 10000]

Number of measurements in a row to trigger detection

Specify the minimum number of frames with the set number of people for the detector to generate an event.  The The value must be in the range [1, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false events , but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases the probability of false events

Start value of alarm range settings5Specify the range of the number of people in the frame. The value must be in the range [0, 100]

...

If necessary, you can configure the detection area. For this, do the following:

  1. Click in the preview window.
  2. Select Area of people counting.
    Image Added
  3. Set the detection area using the anchor points Image Added. You can create multiple areas.
Info
titleNote
  • For convenience of configuration, you can "freeze" the frame. Click the Image Removed button Image Added button. To cancel the action, click this button again.
  • The area for detection is displayed by default. To hide it, click the Image Removed button Image Added button. To cancel the action, click this button again.
  • To delete the detection area, click the Image Added button.

To save the parameters of the detector, click the Apply Image Removed Apply Image Added button. To To cancel the changes, click the Cancel Image Removed button Image Added button.

Configuration of the People counter is complete.

...