Page History

...

1. Go to the settings panel of the BioSmart UniPass object created on the basis of the BioSmart object.
   
   
2. From the Working mode drop-down list, select the controller working mode that corresponds to the serial number of the working model in the controller web interface:
   1. Palm or card—for a successful access, it is necessary to put a palm or a card to the reader. It is used to control one door in both directions, entrance by palm/card and exit by button.
   2. Simplified turnstile—for a successful access, it is necessary to put a palm or a card to the reader. It is used to control two doors, turnstile in both directions, entrance and exit by button without access sensors.
   3. Turnstile with sensors—for a successful access, it is necessary to put a palm or a card to the reader. It is used to control two doors, turnstile in both directions, entrance and exit by button with access sensors.
   4. Card + palm—for a successful access, it is necessary to put a card to the reader and then put a palm. It is used to control two doors, turnstile in both directions, entrance and exit by button without access sensors.
   5. Template on card—for a successful access, it is necessary to put a card with biometric template to the reader.
   6. Custom 1—user configurable model 1.
   7. Custom 2—user configurable model 2.
   8. Custom 3—user configurable model 3.
   9. Custom 4—user configurable model 4.
   10. Custom 5—user configurable model 5.
3. From the Number of templates per user drop-down list, select the number of possible templates of the user's palm vein pattern in the range 1-10. Templates are saved in the controller and used for user identification. If the number of templates saved in the Access Manager is greater than the specified number, only the number specified in the Number of templates per user parameter is saved to the controller. The default value is 5.
4. From the Identification mode drop-down list, select the system operation mode:
   1. Network—operation mode in which access to the controller is assigned from the manufacturer's software BioSmart Studio. Palm templates are stored in the controller memory.
   2. Local—operation mode of the BioSmart UniPass controller that differs from the Network operation mode by the database storage logic.
   3. Server identification—operation mode in which palm templates are stored on an external biometric identification server instead of the controller local memory. In this mode, comparison of biometric data is performed on an external server, which allows you to expand the number of templates and increase the speed of identification. The following parameters of the external Biometric Identification Server must be specified:
      1. In the Host IP field, enter the IP address of the Biometric identification Server.

      2. In the Host port field, enter the port of the Biometric identification Server.
         
         

         Note
         title Attention!
         If the Server identification mode is used, then the Biometric biometric identification Server must be configured on the parent object (see Configuring the Biometric Identification biometric identification Server).

         
         

5. Click the Save configuration button to write the settings to the controller (see Managing the configuration of the BioSmart UniPass and Biosmart PV-WTC controllers).
6. Click the Apply Image Removed button.

Configuring the BioSmart UniPass controller is complete.