Page History

...

• the client to the server without having to re-enter the server name, username, and password when starting the app;
• the client to servers that belong to different domains (see Cross-System client);
• the client to the nodes of the Failover failover system (see Configuring Failover VMS).

...

1. Go to the Settings tab → the Options tab → Special options → Automatic connection.Image Removed
2. Specify the required settings listed in the table:
   

   Parameter	Value	Description
   Automatic connection parameters
   Username		Enter the username and password for automatic authentication when connecting to the servers. If you leave these values blank, you must log in manually when you start the client Note title Attention! The Cross-System client connects to all servers using a single username-password pair that must be created in each domain (see Cross-System client).
   Password
   Connection timeout		The default value is

60

3. 15 seconds. Specify the time in seconds to wait for a successful connection before considering the attempt unsuccessful. When you use this setting, an attempt to automatically connect is made immediately. If unsuccessful, the server waits for the user-specified timeout period and then retries to connect. The value must be in the range [5, 300]
   Number of connection attempts		The default value is 1. Set the maximum number of attempts to automatically connect after the specified timeout. The value must be in the range [1, 100]
   Connection type
   Normal connection		Provides connection to one server, while other servers serve as backups. If the main server is unavailable, connections to the backup servers are made sequentially. All servers must be in the same domain
   Cross-system connection		Provides simultaneous connections to several servers that belong to different domains. The main server connects first, followed by other servers (regardless of the availability of the main server). All servers must be in different domains
   Servers for automatic connection
   Select server		Select the server from the drop-down list or enter the IP address of a server
   Port		The default value is 20109. Specify the port to connect to this server. If you leave the field blank, the connection is established via the standard port that is set by default

4. Click the Add button.

...

If you want to configure automatic connection to a node of the Failover failover system:

1. Set the Via cluster checkbox.
2. In the Select server field, enter the IP address of any server of the cluster.
3. Click the button.
4. From the drop-down list, select a node that you want to add to autoloading. 
5. Click the Add button.
6. Click the Apply  button. To cancel the actions, click the Cancel button.

...