Page History

...

1. Open the Hardware tab in the System Settings window (1).
2. In the object tree on the left side of the Hardware tab, select the Traffic Detector object representing the Traffic Detector module to be set up. The settings panel of the selected object will open on the right side of the window (2).
   Image Modified
3. In the Beginning time field, enter for how long (in seconds) the jam conditions must be satisfied for the start of the jam to be detected (3).
4. In the Average speed threshold field, enter the minimum average traffic speed which is still not considered to be a jam. When the average traffic speed remains lower than this value for a certain period of time, a traffic jam may be detected (if other conditions are satisfied) (4).
   The threshold is set in km/h.

5. In the Traffic jam threshold field, enter the maximum road load (in percent) which is still not considered to be a jam. When the road load remains higher than this value for a certain period of time, a traffic jam may be detected (if other conditions are satisfied).
   If the overall road load is lower than that specified, no traffic jam is detected.

   Info
   title Note.
   The road load parameter is calculated using the following formula:   , where T0 is the total of the time periods when vehicles were present in the loop detector zone, and T is the time period set in the Statistics update time field.

6. Click Apply (6).

...