Versions Compared

Old Version 1

changes.mady.by.user Sofya Uyutova

Saved on

compared with

New Version Current

changes.mady.by.user Lyubov Kasyanova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To configure a V2000 controller's keypad types, use the setup panel of the relevant Keypad type (V2000) object. To find this object,go to the Settings dialog box, click the Hardware tab, select the relevant VertX V2000 NC/RI object, and browse its object subtree.

Image Modified

To configure a keypad type:

  1. Go to the Keypad type (V2000) object's setup panel.
    Image Modified
  2. In each of the fields 0, 1, ..., 9, enter the value that the controller receives when the field's keypad key is pressed(1).
  3. In the 0x0A field, enter the value that the controller receives when the keypad's *key is pressed(1).
  4. In the 0x0B field, enter the value that the controller receives when the keypad's #key is pressed(1).
  5. Click Apply to save the changes (2).

...

The settings of the Keypad type object are presented in the figure:

Image Modified

 

Note
titleAttention!

Presence of parity bits is not necessary. Parity bits combinations are also available. In the considered example the HID ProxPro 5355AGK11 has parity bits it this order exactly.  But the manufacturer can use other combinations:

E XXXXX……XXXXX O  Even parity bit in the beginning (0), odd parity bit in the end (1)

E XXXXX……XXXXX E   Even parity bits in the beginning and in the end (0)

O XXXXX……XXXXX E   Odd parity bit in the beginning (1), even parity bit in the end (0)

O XXXXX……XXXXX O   Odd parity bits in the beginning and in the end (1)

Enter the corresponding values in decimal form depending on the combination which is in use by manufacturer.

Ask the manufacturer about the type of combination which is in use if it is not specified in the manual for reader.